Applications
- AB-177Automatic determination of the bromine number and the bromine index in petroleum products
The bromine number and bromine index are important quality control parameters for the determination of aliphatic C=Cdouble bonds in petroleum products. Both indices provide information on the content of substances that react withbromine. The difference between the two indices is that the bromine number indicates the consumption of bromine in gfor 100 g sample and the bromine index in mg for 100 g sample.This Application Bulletin describes the determination of the bromine number according to ASTM D1159, ISO 3839, BS2000-130, IP 130, GB/T 11135 and DIN-51774-1. The bromine index determination for aliphatic hydrocarbons is described according to ASTM D2710, IP 299, GB/T 11136 and DIN 51774-2. For aromatic hydrocarbons the determination of the bromine index is described according to ASTM D5776 and SH/T 1767. UOP 304 is not recommended for the determination of the bromine number or bromine index because its titration solvent contains mercuric chloride.
- AN-NIR-094Bromine number in pyrolysis gasoline
This application note presents near-infrared spectroscopy (NIRS) as an alternative for bromine number determination in pyrolysis gasoline.
- AN-T-182Determination of the bromine number in petroleum products and aliphatic olefins according to ASTM D1159
The bromine number is an important parameter for the determination of aliphatic C=C double bonds in petroleum products. The bromine number is usually determined using electrochemical titration at 5 °C, where the bromine is generated in situ from a bromide/bromate solution. For the titration, a solvent mixture of glacial acetic acid, methanol, and chloroform is used. In this Application Note, the toxic chloroform was replaced with diethyl carbonate.
- AN-T-187Bromine number in petroleum distillate
The bromine number indicates the degree of unsaturation and relies on the simple addition of bromine to the double bonds of alkenes. One mole of bromine is consumed for each mole of carbon-carbon double (C=C) bond present in a substance. In petroleum products, the bromine number corresponds to the olefin content.Normally, chlorinated solvents are used for the determination of the bromine number. In this Application Note they have been replaced by toluene. This makes the determination more ecological. The titration is performed automatically on an OMNIS system in combination with a double Pt-wire electrode. With this setup, a fast and accurate determination by potentiometric titration can be realized.
